36 EN
Master Page: Left
Wide mode
DV WIDE (Factory-preset: OFF)
OFF: Records with no change in the screen ratio.
For playback on a TV with a normal screen ratio.
16:9SQ* : For playback on TVs with an aspect
ratio of 16:9. Naturally expands the image to fit
the screen without distortion. The indicator
appears. When using this mode, refer to your
wide-screen TV’s instruction manual. During
playback/recording on 4:3 TVs/LCD monitor/
viewfinder, the image is elongated vertically.
D.WIDE* : The indicator appears. The
zoom range is extended beyond the maximum
optical zoom wide angle range. This mode’s wide
angle setting is equivalent to using a 0.7X wide
conversion lens. Zooming is possible from 0.7X to
a magnification set in CAMERA Menu. This mode
is suitable for shooting in a small room.
* Not available when the Recording Mode Switch
is set to “HD” or “MEMORY”.
Wind cut
WIND CUT (Factory-preset: OFF)
OFF: Disengages the function.
ON : Helps cut down on noise created by
wind. The “ ” indicator appears. The quality of
the sound will change. This is normal.
Colour bar
COLOR BAR (Factory-preset: OFF)
OFF: Colour bars do not appear.
ON: Colour bars appear on screen which allows
colour settings to be adjusted quickly and easily
for natural-looking picture reproduction. Colour
bars are recorded in the image by shooting with
the setting to “ON”.
SYSTEM
Beep, melody and shutter sound
BEEP (Factory-preset: OFF)
OFF: Even though not heard while shooting,
shutter sound is recorded on the tape.
BEEP: The beep sounds when the power is turned
on or off, and at the beginning and end of
recording. It also activates the shutter sound
effect. (੬ pg. 26, 42)
MELODY: Instead of a beep, a melody sounds
when any operation is performed. It also activates
the shutter sound effect. (੬ pg. 26, 42)
Tally lamp setting
TALLY (Factory-preset: ON)
OFF: The tally lamp remains off at all times.
ON: The tally lamp comes on to signal the start of
recording.
Remote control setting
For details, refer to “USING THE REMOTE
CONTROL UNIT” (੬ pg. 56).
REMOTE (Factory-preset: ON)
OFF: Disables the remote control operations.
ON: Enables the remote control operations.
Priority setting
When the viewfinder is pulled out while the LCD
monitor is opened, you can select which one to use.
PRIORITY (Factory-preset: LCD)
LCD: Allows you to use the LCD monitor.
FINDER: Allows you to use the viewfinder.
BOTH: Allows you to use both the LCD and
viewfinder.
System Menu
RECORDING MENUS (cont.)
JY-HD10PAL.book Page 36 Wednesday, June 25, 2003 2:02 PM
