10. TIME CODE OPERATION
E-66
The GY-DV5000 also incorporates a time code reader. Therefore, when the unit enters record mode from record-standby mode, it
can read the time code data recorded on the tape and record time codes in continuation of the existing data. The recorded user’s
bit data are identical to the user’s bit data recorded on tape.
● However, approximately ±1-frame variations may occur in scene accuracy.
To enable this function, set the time code related switches as follows before starting recording.
OPEN
CH-1
AUDIO INPUT
AUDIO SELECT
CH-2
CH-1 CH-2
FRONT
REAR
AUTO
MANUAL
AUDIO
LEVEL
CH-1 CH-2
PULL
OPEN
LCDBRIGHT DISPLAY
COUNTER
CH-1
AUDIO INPUT
AUDIO SELECT
CH-2
CH-1 CH-2
FRONT
REAR
AUTO
MANUAL
TC GENE.
TC
MONITOR
SELECT
AUDIO
LEVEL
AUDIO INPUT
CH-1 CH-2
CH-1
MIX
CH-2
FRONT REAR
LINE
MIC
+48V
PRST
REGEN FREE
REC
UB
LCD BRIGHT DISPLAY
10-3
Recording Time Codes in Continuation of Time Codes Recorded on Tape
TC GENE switch
Setting
■ Set the TC GENE switch inside the cover on the side to
REGEN.
10-4 Reproducing Time Codes
The GY-DV5000 incorporates a time code reader. During playback, the time code or user’s bit data recorded on the tape is
displayed on the LCD monitor or in the viewfinder. (Status screen)
Status screen
Setting
☞ See “Displaying Time Code” on page 64.
CAUTION:
A time code with a duration of more than 2 hours may not
be displayed correctly by DV components for general
consumer use, as some of these lack the capability to
display longer time codes.
00:00:00:00
12
.2V
PLAY 01/02/03 01:23:45
Playback time code indication
