Version 1.10
How to use Sony 26Pin cable with RM-P210U
1- Setup for Sony Cable
d h th tti f S35 & S36 di
emove
e
op-cover an
c
ange
e se
ng o
p-sw
c
oc
s
located on the 26-pin connector board.
(a) S35: All switches must be set UP.
(b) S36: All switches must be set DOWN.
2- Adjustment
adjustment of the transmit Voltage (refer to SM)
.
(a) VOLT ADJ 15V: adjust to 15VDC +/- 0.2V
(b) VOLT ADJ 17V: adjust to 16VDC +/- 0.2V
(c) VOLT ADJ 19V: adjust to 16VDC +/- 0.2V
Note 1: If the Volta
e is not correct, the viewfinder ma
be dama
ed due to over heatin
.
Note 2: Receive Voltage at pin-A and pin-B of the 26-pin MUST be lower than 15V. If the voltage exceeds 15VDC, adjustment
of (a) “VOLT ADJ 17V” and (b) “VOLT ADJ 19V” must be re-adjusted from 16VDC to 15VDC.
GY-HD250U/KA-HD250U and JVC CCUs Power connectivity table
RM-P210U RM-P200U RM-P300U
VF-P400 VF-P550B VF-P400 VF-P550B VF-P400 VF-P550B
-
50m(VC-P113) Operation OK OK NG NG OK OK
100m(VC-P114) Operation OK OK NG NG NG NG
42
