EN7
3
2
1
5
4
How To Attach The Grip Belt
1 Remove the pad and separate the two straps.
2 Thread one end of the strap through the
eyelet, then pass the other end through the loop.
3 Repeat the same procedure to attach the strap
to the other eyelet.
4 Connect the strap and
and thread the strap
through the buckle, then adjust the grip
(੬ pg. 12).
5 Attach the pad.
How To Attach The Strap
1 Thread one end of the strap through the eyelet,
then pass the other end through the loop.
2 Attach the screw to the tripod mounting socket.
To tighten the screw firmly, use a coin, etc.
3 Adjust the length with the adjuster.
NOTES:
●
You can use the strap as a shoulder strap by
adjusting the length with the adjuster.
●
Because the screw may cause damage to the
camcorder, make sure to attach the screw to the
tripod mounting socket when carrying the
camcorder.
●
Use the strap only with this camcorder.
●
Do not grip the camcorder too firmly when the
screw is attached. Doing so may cause damage to
the tripod mounting socket.
1
2
3
