EN
ENEN
EN
'
''
'
Master Page: Right-start
AUTOMATIC DEMONSTRATION
Automatic Demonstration takes place when “DEMO
MODE” is set to “ON” (factory-preset).
Ⅲ Automatic Demonstration starts when there is no
operation for about 3 minutes after the Power
Switch is set to “A” or “M” and no cassette is in
the camcorder.
Ⅲ Performing any operation during the
demonstration stops the demonstration
temporarily. If no operation is performed for more
than 3 minute after that, the demonstration will
resume.
Ⅲ “DEMO MODE” remains “ON” even if the
camcorder power is turned off.
To cancel Automatic Demonstration
1
Set the Power Switch to “M” while pressing down
the Lock Button located on the switch.
2
Open the LCD monitor fully, or pull out the
viewfinder fully.
3
Press MENU. The Menu Screen appears.
4
Press + or – to select “s”, and press SELECT/
SET. The SYSTEM Menu appears.
5
Press + or – to select “DEMO MODE”, and press
SELECT/SET. The Sub Menu appears.
6
Press + or – to select “OFF”, and press SELECT/
SET.
7
Press + or – to select “BRETURN”, and press
SELECT/SET twice. The normal screen appears.
NOTE:
Detach the lens cap to see the actual changes of the
Automatic Demonstration activated on the LCD
monitor or viewfinder.
Automatic Demonstration
ST
M SY E
DEM– MO DE O
NO
OFF
Power Switch
Lock Button
MENU Button
Sub Menu
SELECT/SET
Button
+/- Button
GR-D200US.book Page 9 Friday, April 11, 2003 1:05 PM
