EN33
01
04
03
06
02
05
<
DELETE
>
NEXT
S
A
E
E
L
X
L
L
I
E
T
CT
DELETE
C
E
A
N
N
T
C
E
E
R
L
DELETE
C
E
A
N
N
T
C
E
E
R
L
DELETE
Deleting Images
Previously shot images can be deleted either one at a time
or all at once.
1
Set the Power Switch to “ ”. If the DSC Lamp is
not lit, press REFRESH for approx. 1 second to select
“DSC”.
2
Press MENU. The Menu Screen appears.
3
Rotate MENU to select “DELETE” and press it. The
DELETE Menu appears.
TO SELECT AN IMAGE BY BROWSING
IMAGES STORED IN MEMORY
Before doing the following, perform steps 1 through 3 above.
4
Rotate MENU to select “SELECT” and press it. The
Delete Select Menu appears.
5
Rotate MENU to move the frame to the desired image
that you wish to delete and press it. An “ ” appears
above the selected image.
Repeat this procedure for all images that you wish to
delete.
6
Rotate MENU upward to select “NEXT” and press it.
The Delete Execute Menu appears.
7
Rotate MENU to select “ENTER” and press it. After
“ENTER” blinks, the selected images are deleted and
the Menu Screen reappears. Press MENU again to
close the Menu Screen.
•To cancel deletion, rotate MENU to select “CAN-
CEL” and press it twice. The Menu Screen closes.
TO DELETE ALL IMAGES
Before doing the following, perform steps 1 through 3 above.
4
Rotate MENU to select “ALL” and press it. The Delete
Excute Menu appears.
5
Rotate MENU to select “ENTER” and press it. After
“ENTER” blinks, all the images are deleted and the
Menu Screen reappears. Press MENU again to close
the Menu Screen.
•To cancel deletion, rotate MENU to select “CANCEL”
and press it twice. The Menu Screen closes.
NOTES:
●
Before deleting some still images stored in memory,
perform “Protect” for the necessary ones (
੬
pg. 32) or
save them on a PC so that you do not lose them
accidentally (
੬
pg. 34).
●
Protected images (
੬
pg. 32) cannot be deleted with the
above operation. To delete them, remove protection first.
●
If the remaining number of shots is not 30 in the FINE
mode or 60 in the STANDARD mode when “ALL” is
selected on the DELETE Menu, initialise the camcorder’s
memory (
੬
pg. 61).
Power Switch
Display
CAUTION:
While “ENTER” is selected on the Delete
Execute Menu and it is blinking, switching
off the camcorder or removing the power
supply unit (battery pack or AC Adapter)
may cause the camcorder’s built-in memory
to become corrupt. Never remove the
power supply unit at this stage.
MENU Wheel
REFRESH Button
DELETE Menu
In case of “ALL”
Delete Select
Menu
In case of
“SELECT”
Delete Execute
Menu
Menu Screen
Makes the DSC lamp
come on.
