29
PROCEDURE 10FWD WHEELCHAIRS
F
W
D
W
H
E
E
L
C
H
A
I
R
S
Refer to INSTALLING/
REMOVING BATTERY
BOXES in this procedure
of the manual.
FIGURE 2 - TRANSPORTING EXCEL -
CAPTAIN'S SEATS
Refer to INSTALLING/RE-
MOVING FOOTRESTS or
INSTALLING/REMOVING
ELEVATING LEGRESTS
in PROCEDURE 3 of this
manual.
CAUTION
HIGH BACK CAPTAIN'S
SEATS ONLY - Discon-
nect limit switch BE-
FORE removing seat -
damage to seat can
occur.
Refer to DISCONNECT-
ING/CONNECTING LIMIT
SWITCH in this procedure
of the manual.
Refer to BATTERY TRAY
in this procedure of the
manual.
Push Brackets
Crossbraces
2. Remove the Captain's Seat. Refer to REMOVING/
INSTALLING CAPTAIN'S SEAT in this procedure of
the manual.
3. Remove the shrouds. Refer to REMOVING/INSTALL-
ING SHROUDS in this procedure of the manual.
4. Remove the batteries and footrests/legrests from the
wheelchair. Refer to FIGURE 2.
ADJUSTING/REPLACING
TELESCOPING FRONT RIGGING
SUPPORT (FIGURE 3)
1. Lift up on the crossbraces until they release from the
H-blocks on the wheelchair frame.
2. Remove the phillips bolt and locknut that secure the
front H-block to the wheelchair frame.
3. Remove the two (2) locknuts and socket bolts that
secure telescoping front rigging support to wheelchair.
4. If necessary, remove the hex bolt and locknut that
secures the battery charger connector bracket to
the wheelchair.
Adjusting
1. Position the telescoping front rigging support to the
desired depth.
5. HIGH BACK CAPTAIN'S SEATS ONLY - Connect
the limit switch. Refer to DISCONNECTING/CON-
NECTING LIMIT SWITCH in this procedure of the
manual.
FOLDING.
1. HIGH BACK CAPTAIN'S SEATS ONLY - Discon-
nect the limit switch. Refer to DISCONNECTING/
CONNECTING LIMIT SWITCH in this procedure of
the manual.
FIGURE 3 - ADJUSTING/REPLACING
TELESCOPING FRONT RIGGING SUPPORT
Wheelchair
Frame
Socket Bolt
H-Block
Phillips Bolt
FRONT SOCKET
BOLT
POSITIONS (IN
INCHES DEEP):
Telescoping Front
Rigging Support
DO NOT USE WITH FRONT
SOCKET BOLT
Locknuts
Front Socket Bolt
18
16
and
17
Battery
Charger
Bracket
Hex Bolt
and Locknut
