A SERVICE OF

logo

Open as PDF
next previous
Setting the SCSI Security Jumpers
Before you begin:
Read the “Laser Safety Information” on page xiv.
Read “Safety Considerations” on page 4-2 and “Handling Static Sensitive
Devices” on page 4-3.
Remove the server cover (see “Removing the Cover” on page 4-4).
To increase server security, the external SCSI connector can be disabled by
changing jumpers inside the server.
1. Locate the SCSI security jumpers in the following figure.
J35
J36
2. Remove the riser card bracket to access the jumpers. See “Removing the Riser
Card Support Bracket” on page 4-34.
3. To disable the external SCSI connector, move the jumper on J35 to the front two
pins, and move the jumper on J36 to the rear two pins.
Chapter 4. Installing and Removing Options 4-33