A SERVICE OF

logo

Open as PDF
next previous
10
42652-01•10/25/07•HunterFanCompany
Plug
Connector
Detail
WARNING:Useonlythelightxturesuppliedwiththisfanmodel.
7-1. Toattachtheupperswitchhousing,partiallyinstalltwo#6-32x
3/8” housing assembly screws into the switch housing mounting
plate.
7-2. Alignthekeyholeslotsinthehousingwiththehousingassembly
screws.
7-3. Turnthehousingcounterclockwiseuntilthehousingassembly
screws are firmly situated in the narrow end of the keyhole slots.
Installtheremaining#6-32x3/8”screwintothehousing.Tighten
all three screws firmly.
CAUTION: Make sure the upper switch housing is securely attached
to the switch housing mounting plate. Failure to properly attach and
tighten all three assembly screws could result in the switch housing
fixture falling.
7-4. Toattachthelowerswitchhousing,connecttheupperplug
connector from the motor to the lower plug connector in the
lower switch housing assembly.
Note: Both plug connectors are polarized and will only fit together
one way. Make sure the connectors are properly aligned before
connecting them. Incorrect connection could cause improper
operation and damage to the product.
7-5. Placethelowerswitchhousingassemblyovertheupperswitch
housing.Alignthesidescrewholesintheupperandlowerswitch
housings.Attachthelowerswitchhousingtotheupperswitch
housingwiththree#6-32x3/8”housingassemblyscrews.
Steps 7-1 – 7-3
Housing
Assembly
Screw
Upper
Switch
Housing
Housing
AssemblyScrew
Step 7-4
Lower
Switch
Housing
Plug
Connector
7 • Completing Your Installation With a Multi Staked Light Fixture