13
42650-01 • 08/17/09 • Hunter Fan Company
7 • Completing Your Installation With or Without a Bowl Light Fixture (Continued)
Lower Switch
Housing
readed Rod
Steps 7-14 – 7-19
Step 7-20
Cap
Plug Button
Uninstalling the Light Fixture
7-14. Remove the lower switch housing screws, then remove the lower
switch housing.
7-15. To uninstall the light xture, rst disconnect the 9-pin plug
connectors between the black wire and the black/white wire.
7-16. Disconnect the plug connectors between the two white wires.
7-17. Uninstall the nut and washer from the end of the light xture
inside the lower switch housing.
7-18. Unscrew the threaded rod of the light xture from the lower
switch housing.
7-19. Remove the light xture from the lower switch housing pulling
disconnected wires through the hole in the center of the lower
switch housing.
Note: When removing the wires, pull the thin plug connector
(male) through rst, and then pull the other plug connector
(female) through the hole.
7-20. Install the switch housing cap and plug button to the lower switch
housing.
7-21. Once you have uninstalled the light xture, continue with step
7-6.
7-22. Re-attach the lower switch housing back to the fan and reinstall
the lower switch housing screws.
Lower Switch
Housing
Screw
