8 • Completing Your Installation With or Without a Light Fixture
Your Hunter fan comes with a switch housing assembly and an
optional light xture. is feature gives you the option of installing
the fan with OR without the included light xture. e steps
below direct you whether or not you are installing a light xture.
WARNING: Use only the light xture supplied with this fan
model.
8-1. To attach the upper switch housing, partially install two housing
assembly screws into the switch housing mounting plate.
8-2. Feed the upper plug connector through the center opening of the
housing.
8-3. Align the keyhole slots in the housing with the housing assembly
screws.
8-4. Turn the housing counterclockwise until the housing assembly
screws are rmly situated in the narrow end of the keyhole slots.
Install the remaining housing assembly screw into the housing.
Tighten all three screws rmly.
CAUTION: Make sure the upper switch housing is securely
attached to the switch housing mounting plate. Failure to
properly attach and tighten all three assembly screws could
result in the switch housing and light xture falling.
8-5. If you want to install the light xture, proceed with step 8-6 now.
If you do not want to install the light xture, proceed with step 8-
11 now.
Steps 8-1 – 8-4
Housing
Assembly
Screw
Upper
Switch
Housing
