7 • Completing Your Installation With or Without a Light Fixture (Continued)
7-10. To attach the lower switch housing, connect the upper plug
connector from the motor to the lower plug connector in the
lower switch housing assembly.
Note: Both plug connectors are polarized and will only t
together one way. Make sure the connectors are properly aligned
before connecting them. Incorrect connection could cause
improper operation and damage to the product.
7-11. Place the lower switch housing assembly over the upper switch
housing. Align the side screw holes in the upper and lower switch
housings. Attach the lower switch housing to the upper switch
housing with three housing assembly screws.
If you are not installing the light xture, your installation is
complete. Otherwise, proceed with step 7-12.
7-12. Install one medium base incandescent light bulb (100 Watt
maximum).
7-13. Insert the globe into the xture. Install and tighten the
thumbscrews manually. Do not overtighten.
Note: If thumbscrews are pre-threaded, loosen the screws before
inserting the globe, then retighten securely.
Steps 7-10 – 7-11
Plug
Connector
Steps 7-12 – 7-13
Globe
Lower
Switch
Housing
umbscrews
Switch Housing Assembly Screws
