Steps 3-2 – 3-3
Steps 3-5 – 3-6
3 • Assembling and Hanging the Fan
Low Prole
Washer
Downrod
Canopy
Set Screw
Low Prole Screw
Step 3-7
Canopy Slots
WARNING: Fan may fall if not assembled as directed in these installation
instructions.
3-1. Unbundle the wires from the fan.
For Standard or Angled Mounting:
3-2. To assemble fan to hang down from a at or angled ceiling, insert
the downrod through the canopy. Feed the wires from the fan
through the downrod.
3-3. Loosen the square head set screw on the adapter to install the
pipe and ball assembly. Note: When the pipe and ball assembly
is fully installed, 2-3 threads on the pipe will still be visible; this is
normal. Securely retighten the set screw with a wrench or pliers.
Skip to Step 3-7.
CAUTION: e adapter has a special coating on the threads. Do
not remove this coating; the coating prevents the downrod from
unscrewing. Once assembled, do not remove the downrod.
For Low Prole Mounting:
Note: For low prole mounting, the downrod is replaced with the low
prole washer.
3-4. Remove the set screw from the adapter.
3-5. Place the low prole washer into the canopy. Be sure the green
ground wire is pointing up toward the ceiling.
3-6. Align the holes in the washer with the holes in the adapter.
Assemble securely with three low prole screws.
3-7. Raise the fan and align the slots in the canopy with the tabs on the
ceiling plate.
Ceiling
Plate
Tabs
