© 2005 Hunter Fan Company 41892-01 03/17/2005
5
4. Align the slotted holes (refer to Figure 9) in the ceiling plate
with the pilot holes in the wood support structure. Note: The
isolation pads should be flush against the ceiling.
For Angled Ceilings: Be sure to orient the ceiling plate so that
the arrows on the ceiling plate are pointing towards the ceiling
peak. Refer to Figure 9.
Figure 9 - Locating the slotted holes to use
5. Place a flat washer on each of the two 3" screws and pass the
screws through the slotted holes in the ceiling plate as shown
in Figure 10.
6. Tighten the screws into the 9/64" pilot holes; do not use lubri-
cants on the screws. Do not overtighten.
Figure 10 - Installing the ceiling plate
assembling the blade irons
1. Use the styrofoam packaging to support the motor housing
while assembling the blade irons.
2. Place the blade bracket through the hole in the side of the
lower motor housing. Refer to Figure 11.
3. Install the two blade bracket screws as shown in Figure 11.
Figure 11 - Installing the blade brackets
4. Place the upper motor housing over the adapter as shown in
Figure 12. Align the holes in the upper motor housing with
the holes in the adapter.
5. Partially install the three motor housing screws.
NOTE: Make sure the gap between the upper and lower mo-
tor housing is even all the way around.
6. Securely tighten all three motor housing screws. Refer to Fig-
ure 12.
Figure 12 - Assembling the upper motor housing
assembling the fan
1. Insert the downrod through the canopy and canopy trim ring
as shown in Figure 13. Feed wires from the fan through the
downrod.
2. Screw the downrod into the fan assembly until tight.
IMPORTANT! Tighten allen head set screw as shown in Figure
13 with the included allen wrench.
CAUTION: The downrod has a special coating on the
threads. Do not remove this coating; the coating prevents
the downrod from unscrewing. Once assembled, do not
remove the downrod.
Figure 13 - Assembling the downrod
Slots
Arrows for Orienting
on Angled Ceiling
Ceiling Joist
2 x 4 Brace
Ceiling
Ceiling Plate
Flat Washer
Outlet Box
3” Wood Screw
Blade
Bracket
Screws
Blade Bracket
Lower Motor
Housing
Upper Motor
Housing
Motor
Housing
Screw
Adapter
Hanger Ball/
Downrod Assembly
Canopy
Canopy Trim Ring
Allen Head
Set Screw
41892-01_Rev 03.17.05.pmd 3/18/05, 8:44 PM5
