A SERVICE OF

logo

Open as PDF
next previous
Server cabling 93
For ease of cabling, route the cables in the server before connecting the cables to the SAS hard drive
cage.
NOTE: Port 1 supports hard drives 1 through 4. Port 2 supports hard drives 5 through 8. If you are using a
single channel SAS controller, connect the cable to port 1.
USB cable assembly
The USB cable connects the front panel USB connector to the SCSI backplane.
To remove the component:
1. Power down the server (on page 16).
2. Extend the server from the rack ("Extending the server from the rack" on page 15).
3. Remove the access panel ("Removing the access panel" on page 17).
4. Remove the front bezel ("Removing the front bezel" on page 18).
5. Disconnect all cables from the media board.
6. Remove the media board ("Removing the media board" on page 37).