Getting Started
LED Backlit Flat TV Instruction Manual EN-9
EN
Preparing Your Remote Control
Installing the Batteries
1. Open the battery cover.
2. Install two AAA batteries. Make sure that you
match the + and – symbols on the batteries with
the + and – symbols in the battery compartment.
3. Replace the battery cover.
Remote Control and Battery Cautions
• Ensure that there is nothing between the remote
control and the remote sensor of the TV set.
• Use the remote control carefully. Do not drop the
remote control on the floor.
• Sunlight, or other strong light, will interfere with
the signal from the remote control. Avoid using
near fluorescent lights or neon signs.
• Do not place the remote control in direct heat or in
a damp place as you may damage the remote.
• Danger of explosion if battery is incorrectly
replaced. Replace only with the same or equivalent
type. The batteries (battery pack or batteries
installed) shall not be exposed to excessive heat
such as sunshine, fire or the like.
• If your TV is not to be used for a long period of time,
remove the batteries from the remote control.
• Do not dispose of the batteries with standard
household waste. Do not throw them in a fire.
Dispose of the battery according to local
regulations.
Initial Setup
The first time you turn on your TV, the setup wizard
guides you through setting up basic settings including
the menu language and auto tuning.
1. Make sure that you have:
• Installed the remote control batteries. (See page
9 for details)
• Connected an antenna or cable TV. (See page 7
for details)
• Connected the power cord on the back of the TV
to a working power outlet.
For LE32F600, connect the supplied power cord
to the AC IN jack on the back of the TV and to a
working power outlet.
2. Press to turn on the TV. The setup wizard screen
opens.
3. Press S/T/W/X to highlight your OSD language,
then press OK.
4. The channel tuning starts. Wait a few minutes for
the tuning to complete.
5. When the tuning is finished, the TV will tune to the
first channel stored on the channel list.
Note
• The initial setup process may vary depending on
different systems. Follow the on-screen instructions to
complete the setup.
Getting Started
