Disc Sanding
To perform disc sanding operations:
1.
The disc table can be positioned from
0˚ to 45˚, relative to the plane of the sanding
surface.
2.
3.
Figure 18
For sanding curves or irregular
shapes, remove the miter gauge from the
disc table. Always keep the workpiece on the
side of the wheel that is rotating down toward
the table. This will keep the workpiece from
flying out of your hands from the rotational
forces.
Miter Sanding
To perform miter sanding operations:
1.
2.
Figure
19The miter gauge can be used in
either direction in the slot to achieve the
proper relation of the workpiece to the disc.
Figure 19
Figure 20
