A SERVICE OF

logo

NT 250 PROGRAMMING
Connect a 50 ohm load or 50 ohm antenna to the RF output, connect the
equipment into a mains supply (100÷240 VAC). The equipment is factory
pre-set to 50 W.
Switch ON the power and the yellow V POWER LED will light.
The Display will show:
After 3 seconds the green PLL LOCK led will light and the Display will
show an increasing bar. After a further 5 seconds the green ENABLE will
light and there will be output power.
At this point the Display will show the next parameter:
Level Modulation (MOD > );
Forward Power (FRW 50.0W);
Reflected Power (RFL 0.4W).
WAIT
PROGRAM
SETTING
WAIT
PROGRAM
SETTING
MOD >
FRW 50W RFL 0.4W
PROGRAM
SETTING