Page 18SKU 65044
66164
For technical questions, please call 1-800-444-3353.
TROUBLESHOOTING
Problem Possible Cause Possible Solution
Quality of cut is poor. Cutting tool is above workpiece 1.
center line.
Lathe speed too slow.2.
Cutting tool is dull.3.
Cutting too aggressively.4.
Lower cutting tool to center line of 1.
workpiece.
Increase lathe speed.2.
Sharpen or replace cutting tool.3.
Use a lighter touch.4.
Excessive vibration when
turning thin workpieces.
Cutting tool is positioned below 1.
workpiece center line.
Cutting too aggressively.2.
Raise cutting tool to center line of 1.
workpiece.
Use a lighter touch.2.
Excessive vibration when
turning larger workpieces
or bowls.
Headstock and/or tailstock 1.
improperly located at ends of
workpiece.
Workpiece is unbalanced.2.
Check for proper workpiece centers. 1.
Cut off stock until workpiece is 2.
balanced.
Lathe will not turn on. Speed control lever not in its 1.
lowest speed setting.
Electrical outlet not working or 2.
is of wrong voltage.
Blown fuse or tripped circuit 3.
breaker.
Turn speed control lever to its lowest 1.
speed setting.
Plug lathe into a working, 220 volt, 2.
grounded, electrical outlet.
Replace fuse or reset circuit breaker.3.
Lathe will not turn off. Damaged or faulty power switch
and/or internal wiring.
Unplug the lathe from its electrical outlet
immediately. Do not operate lathe
until it is repaired by a qualied service
technician.
Record Product’s Serial Number Here:
Note: If product has no serial number, record month and year of purchase instead.
Note: Some parts are listed and shown for illustration purposes only, and are not avail-
able individually as replacement parts.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS
LIST AND ASSEMBLY DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL
ONLY. NEITHER THE MANUFACTURER OR DISTRIBUTOR MAKES ANY
REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR
SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR
SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE
MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS
AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND
LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER ASSUMES ALL
RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL
PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR
HER INSTALLATION OF REPLACEMENT PARTS THERETO.
