9
Figure 2 - Display
showing the lock mode
Start / Pause
This button has a number of functions. It serves to:
· Start the DishDrawer once the desired wash program has been selected.
· Interrupt the wash program while in operation.
To pause the DishDrawer, press the Start / Pause button and wait until you
have heard two additional beeps before you open the drawer, allowing the lid
seal to deflate. While in pause mode, the light above the Start / Pause button
will flash.
· Restart the DishDrawer after being paused.
You may notice a delay after the Start / Pause button has been pressed. During
this time the lid seal will be inflating.
· One Button Start.
This starts the DishDrawer and will run the last wash program used.
NOTE:
Under no circumstances do we recommend that you open the DishDrawer while in
operation unless you have pressed the Start / Pause button. If the drawer is opened
during the wash program, there is a possibility of getting wet, burnt, or damaging the
DishDrawer. There are safety mechanisms in place to stop the DishDrawer if it is
opened.
If a red light appears above the Start / Pause button, check the secondary control panel
and note which lights are lit up. If the red lights above the rinse and fast are lit this
indicates that the door was opened during the wash program. To remove this fault,
ensure the drawer is closed and press Power. The DishDrawer will now be ready to
start from the beginning of the wash program. You may have to add more detergent in
the dispenser and then press Start / Pause button to start the DishDrawer. The
DishDrawer will not restart where it was interrupted after a fault.
Lock
The Lock function disables all the other functions on the
DishDrawer. This function is useful when cleaning the
control panel and can also prevent children from turning
the DishDrawer on or off accidentally. This button can be
used when the DishDrawer is in operation and will remain
active until the Lock is deactivated.
To activate this function, press and hold the Lock button
until the red light above it appears continuously and is no
longer blinking. All the other buttons are now inactive.
To deactivate this function, press and hold Lock button
until the red light above this button has disappeared.
