8
Mounting the Fan Blades and Cover Switch Cup Assembly
INSTALLATION NOTE
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled may
result in damage to the fan blades.
2. Disassemble switch cup support cover from cover
switch cup assembly removing three screws.
(Figure 15)
WARNING
To reduce the risk of personal injury, do not bend the
blades when installing, balancing or cleaning the fan.
Do not insert foreign objects in between the rotating
blades.
1. Securely fasten the three blades with phillips-head
Figure 14
Figure 15
Support Cover
Switch Cup
Blade Screws
screws with flat washers. (Figure 14)
Phillips-Head
Screw with
Flat Washer
(3 per blade)
3. Remove one of the three screws in the support
bracket. Attach the switch cup support cover to the
support flange by rotating plate and properly positioning
screws in key slots. Install third screw in remaining hole.
Fully tighten all three screws. (Figure 16)
Figure 16
4. Securely attach 9-pin connector from motor
assembly to wiring harness socket within switch cover
assembly. (Figure 17)
WARNING
The color label on these two connectors must
correspond to each other.
Figure 17
