A SERVICE OF

logo

6. Attach speaker wires from the ceiling tile hole to the included four-pole captive screw
connector using one of the following three methods below.
NOTES:
• Be sure that the combined impedance of the speaker system does not equal a
value less than the rated minimum load impedance of the
amplifier.
• The maximum number of wires per terminal are as follows:
Number of Wires per
Connection Point
Maximum
Wire Gauge
1 12 AWG
2 16 AWG
Wire Gauge Table
• Do not tin the wires. Tinned wires do not hold tight in the captive screws and
can break easily after several bends.
• Strip no more than 3/16" (5 mm) of insulation from the end of the wire before
inserting it into the captive screw connector.
Do not tin the wires!
SF 26X User Guide • Installation 4