A SERVICE OF

logo

Chapter 1
With the printer facing you, as shown in Figure 1-2, grasp the
side and pull straight up. Very easy. To replace the lid,
procedure.
lid on its left
top
just reverse
the
Figure 1-2
Locate the 2 shipping screws, shown in Figure l-3. These screws are used to
protect the MX-70 from damage during shipping.
Shipping Screws
Turn the printer over and lay it on a soft surface. Using a Phillips type screw-
driver, remove the shipping screws and save them in case you decide later to
lend the printer to Aunt Bernice in Ohio. These screws are in place during ship-
ping to protect the printer from damage and are located as shown in Figure l-3.
Shipping Screws
Figure 1-3
Turn the printer back over when you are ready for the next step.
2