Always turn the power OFF (with the switch on the right side of the
printer) before you change the setting of any of these switches. Any
changes made while the power is on will be ignored until you turn the
printer off and back on. So set all switches with the power off.
Table D-l shows you the functions of all the switches, and the rest
of the appendix explains each of them.
Table D-7. DIP switch functions
Switch 1
See Table D-2.
Switch 2
No. ON
Function
2-1 0 (slashed)
Zero character
2-2 Inactive
Printer select
2-3 CR + LF
Automatic line feed
2-4 Mute
Beeper
Note:
The factory setting of all these switches is OFF:
OFF
0
Active
CR only
Active
Switch 1-1
selects pica or compressed printing. ON is compressed;
OFF is pica. Regardless of the setting, you can still select compressed
with SelecType and either compressed or pica with ESCape codes.
Switch
Z-2 selects draft or Near Letter Quality. When it is ON, the
printer prints in the NLQ mode. When it is OFF, it prints in the draft
mode. If the switch is off, you can still select the NLQ mode with
SelecType or an ESCape code.
Switch l-3
controls the optional cut-sheet feeder, a device that auto-
matically loads single sheets of paper into the printer. When it is ON,
the cut-sheet feeder is enabled. When it is OFF, the cut-sheet feeder is
disabled. Keep it off unless you are using a cut-sheet feeder.
Switch
1-4 selects the paper length. When it is OFF, the length is 11”;
when it is ON, the length is 12”.
D-2
