A-12
Technical Specifications
Flamingo
Rev. C
A5 size APPSPEC.FM
11/5/98 Pass 0
L
Proof Sign-off:
M.Takata _______
K.Nishi _______
K.Pipa _______
nSelectIn/IEEE1284active
GND
Twisted pair return signal.
CG
Connected to the printer chassis. This signal and GND are connected.
+5V
Pull up to + 5 V with 1 k
Ω
.
Ethernet Interface
You can use an IEEE 802.3 10BASE-T/100BASE-TX straight-through shield
twisted pair modular cable via RJ45 connector.
Compatibility mode: Always low.
Negotiation phase: This signal is set high at the same time
that HostBusy is low in order to request
1284 mode.
Reverse data transfer phase: This signal is set high to indicate that the
bus direction is from the printer to the
host. This signal is set low to terminate
1284 mode, setting the bus direction from
the host to the printer.
Reverse idle phase: Same as reverse data transfer phase.
ECP mode: Always high. This signal is set low to
terminate ECP mode and return to
compatibility mode.
