EPSON PowerLite 8000i/9000i Projector
10/99 EPSON PowerLite 8000i/9000i Projector
- 5
Projection Lamp Light
Temperature Light
Using the Remote Control
The remote control uses a line-of-sight infrared signal. To use
the remote control, point it toward one of the remote control
receivers located at the front and back of the projector. You
can use the remote control up to about 32.8 feet (10 meters)
from the projector. (This distance may be shorter if the remote
control batteries are low.) You must also be within a ±30°
angle from the front or rear receiver. The remote control
buttons and commands are shown in the figure to the right.
Note: To be able to use the remote control as a wireless mouse,
make sure you’ve connected the mouse cable to the projector and
your computer.
The five Special Effects buttons are preprogrammed with
the following options:
1. Change the mouse cursor to a stamp
2. Draw a box
3. Use a marker pen
4. Draw a freehand line
5. Clear the screen
Note: The projector may not respond to remote control commands
in these conditions: the R/C (remote control) ON/OFF switch is
in the OFF position; batteries are weak; ambient light is too
bright; a certain type of fluorescent light is present; a strong light
source (such as direct sunlight) shines into the infrared receiver; or
other equipment emitting infrared energy is present (such as a
radiant room heater). Correct these conditions to use the remote
control or control the projector from a computer.
Open the cover just below the
Esc
button to access these
remote control commands:
Light status Meaning
Oran
e and red
flashin
alternately
Projection lamp needs replacin
.
Steady red Projection lamp has burned out. Replace it to
project ima
e.
Flashin
red Problem with projection lamp or lamp power supply.
Off Lamp is functionin
normally.
Light status Meaning
Flashin
oran
e Projector is too hot.
Steady red Projector has turned off automatically because of
overheatin
.
Flashin
red Problem with the coolin
fan or temperature sensor.
Off Projector is functionin
normally.
Power
Freeze
A/V Mute
E-Zoom
R/C ON
OFF
3
1
5
2
4
Enter
Esc
Enter (pointer) button
Esc button
Freeze
A/V mute
E-Zoom
Special effects
buttons (1-5)
Illumination
IR output
Power
R/C ON/OFF
Front
Back
Power
Freeze
A/V Mute
E-Zoom
R/C ON
OFF
3
1
5
2
4
Enter
Esc
Menu
Comp1
S-Video
Auto
P in P Preset
Resize
Video
BNC
Help
- Volume +
Menu
Comp1
S-Video
Auto
P in P
Volume
Help
BNC
Video
Resize
Preset
