Epson PowerLite 821p Projector
9/04 Epson PowerLite 821p Projector - 13
Warning:
This product includes a lamp component that contains mercury
(Hg). Please consult your state and local regulations regarding
disposal or recycling. Do not put it in the trash.
7. Gently insert the new lamp. If it doesn’t fit easily, make sure
it’s facing the correct way.
Caution:
Do not touch the glass portion of the lamp assembly. Touching
the glass could result in premature lamp failure.
8. Once the lamp is fully inserted, tighten its screws.
9. Lower the lamp cover into place. (The opening should be
almost covered, and the top of the lamp cover should be
flush with the surface of the projector.) Then slide the cover
closed and tighten the screw.
10.Reset the lamp timer as described in the next section.
Resetting the Lamp Timer
You must reset the lamp timer after replacing the lamp to clear
the
Replace the Lamp message.
Note:
Do not reset the lamp timer if you have not replaced the lamp. If
you do, the
Lamp Hours will not accurately reflect the number of
hours that the lamp has been used.
1. Connect the power cable and turn on the projector.
2. Press the
Menu button on the remote control and select the
Reset menu. Then press Enter. You see the following:
3. Select
Lamp-Hours Reset and press Enter. You see the
following:
4. Select
Yes and press Enter.
5. Press
Esc to return to the Reset menu or the Menu button
to exit the menu system.
