Control Panel Messages
Control Panel Messages
Messages Description
Form Feed The printer is feeding paper.
Ready The printer is ready to print.
Reset The printer’s current interface has been reset and the buffer is cleared.
Reset All All printer settings have been reset to the user default configuration, the last settings that
were saved.
Reset to Save You should reset the printer to save the current settings.
Self Test The printer is running a self-diagnostic program.
Standby Level X The printer is turned on, but is in energy-saving mode.
(X = 1 or 2)
Warming Up The printer is warming up.
For a complete list of status messages, see your Printer Guide.
Status message list
Messages Description Action
Check Paper Size The paper size setting is different from Make sure the correct size of paper is loaded
the size loaded in the printer. in the tray; then press the Continue button.
Irregular Density The document density is too great. Clear any jammed paper from the multipurpose
The printer stops loading paper. tray paper path.
Image Optimum There printer doesn’t have enough If the printout is not acceptable, try limiting
memory to print the page at the the number or size of graphics on the page.
specified resolution. The printer
automatically reduces the print quality Turn off the Image Optimum setting in the
so it can continue. SelecType Config menu.
Maintenance Req An internal printer part needs Press the Continue button to print. Make sure you
<error number> to be replaced. note the error number and contact your dealer.
For a complete list of error messages, see your Printer Guide.
Error message list
Continue
▲
9
