- 4 -
E
6
This projector has three Light-Block Sheets. Use the Light-Block Sheet corresponding with the lens. (Refer
to the list below.)
Set the Light-Block Sheet through the lens.
Make sure the shape of the Light-Block Sheets are correct and be sure to set them as shown in the Fig. 8.
NOTE:
●
Be sure to set each Light-Block Sheet as shown in Fig. 8.
●
Make sure the mark (TOP and BACK) on the Light-Block Sheets are correct and set them properly.
Light-Block Sheets for each lens.
Lens Model No.
LNS-S02, LNS-S02Z, LNS-W04
LNS-M01, LNS-T02, LNS-W02,
LNS-M01Z, LNS-W02Z, LNS-S01,
LNS-W03, LNS-W07
LNS-W01, LNS-T01, LNS-W01Z,
LNS-T01Z, LNS-S03,
LNS-W06, LNS-W05
Type No. (Part No.)
TYPE FD1 (610 322 8051)
TYPE FE1 (610 322 7269)
TYPE FF1 (610 322 7788)
Not include Light-Block Sheet
Mounting Base and screws.
Fig-8
For Models
LNS-W01, LNS-W01Z, LNS-T01, LNS-T01Z
LIGHT BLOCK SHEET
Make sure the sheet figure is
correct and put in proper position.
LIGHT BLOCK SHEET
Make sure the sheet figure is
correct and put in proper position.
Mount the Light-Block Sheet
with two (2) screws.
