D-Link DWS-1008 CLI Manual 244
clear dot1x timeout auth-server
Resets to the default setting the number of seconds that must elapse before the switch times out
a request to a RADIUS server.
Syntax: clear dot1x reauth-period
Defaults: The default is 30 seconds.
Access: Enabled.
Examples: To reset the default timeout for requests to an authentication server, type the following
command:
DWS-1008# clear dot1x timeout auth-server
success: change accepted
See Also:
• set dot1x timeout auth-server
• show dot1x
clear dot1x timeout supplicant
Resets to the default setting the number of seconds that must elapse before the switch times out
an authentication session with a supplicant (client).
Syntax: clear dot1x timeout supplicant
Defaults: The default for the authentication timeout sessions is 30 seconds.
Access: Enabled.
Examples: Type the following command to reset the timeout period for an authentication
session:
DWS-1008# clear dot1x timeout supplicant
success: change accepted
See Also:
• set dot1x timeout supplicant
• show dot1x
