xStack
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
479
config stp version
Purpose Used to enable STP globally.
Syntax
config stp version [mstp | rstp | stp]
Description If version is configured as stp or rstp, all currently running MSTIs should be disabled. For
version is configured as mstp, current design is enabled all available MSTIs (assume that
CIST is enabled). Futher discussion needed to decide whether we let user to enable the
MSTIs.
Parameters
version - To decide to run under which version of STP.
mstp - Multiple Spanning Tree Protocol.
rstp - Rapid Spanning Tree Protocol.
stp - Spanning Tree Protocol.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To config stp version:
DGS-3627:admin# config stp version mstp
Command: config stp version mstp
Success.
To config stp version with the same value of old configuration:
DGS-3627:admin# config stp version mstp
Command: config stp version mstp
Configure value is the same with current value.
Fail!
config stp priority
Purpose Used to configure the instance priority.
Syntax
config stp priority <value 0-61440> instance_id <value 0-15>
Description One of the parameters used to select the Root Bridge.
Parameters
priority - The bridge priority value must be divisible by 4096.
instance_id - Identifier to distinguish different STP instances.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To config stp instance_id:
