144 Installing System Components
Figure 3-28. Replacing the System Battery
4
If installed, remove the expansion card from the expansion-card slot.
See "Removing an Expansion Card" on page 126.
5
If installed, remove the storage controller card. See "Removing the Storage
Controller Card" on page 129.
6
To remove the expansion-card riser, press the blue tabs on the
expansion-card riser and lift it from the chassis. See "Removing an
Expansion-Card Riser" on page 127.
7
Locate the battery socket. See "Jumpers and Connectors" on page 193.
CAUTION: To avoid damage to the battery connector, you must firmly support the
connector while installing or removing a battery.
8
Support the battery connector by firmly holding the positive side of
the connector.
1 system battery 2 negative side of battery connector
3 positive side of battery connector
book.book Page 144 Friday, November 20, 2009 2:56 PM
