Error detected in reading from
or writing to the NVRAM
Press the Power button to reset
the printer.
The printer is unable to initialize
memory.
Press the Power button to reset
the printer.
A general hardware failure has
occurred, and the printer is
unable to detect what part of the
hardware system failed.
Press the Power button to reset
the printer.
A checksum error on the Read-
only memory has occurred.
Press the Power button to reset
the printer.
The printer failed to initialize or
calibrate the paper feed system.
Disconnect the printer power cable,
check for paper jams, and then
reconnect the power cable.
Flash Programming - out
of memory
The printer is unable to program
flash memory.
Press the Power button to reset
the printer.
Print Incomplete (Bad
data to print head or
more data expected for
swath)
The printer carrier stopped
before a print job was
completed.
Press the Power button to reset
the printer.
Incorrect data has been sent
from the computer to the
printer.
Press the Power button to reset
the printer.
A short circuit in the print head
has occurred.
Disconnect and then reconnect the
printer power cable. Reinstall the
ink cartridges. For more
information, see Replacing Ink
Cartridges.
The printer cannot determine
the temperature of the print
head due to a problem in the
mono TSR circuit.
Reinstall the black ink cartridge. For
more information, see Replacing Ink
Cartridges.
The printer cannot determine
the temperature of the print
head due to a problem in the
color TSR circuit.
Reinstall the color ink cartridge. For
more information, see Replacing Ink
Cartridges.
The paper system control failed.
Press the Power button to reset
the printer.
The scan carrier stalled during a
scan job.
Turn off the printer, wait a few
seconds, and then turn on the
printer.
NOTE: Contact Customer Support at www.support.dell.com if the errors are not resolved.
