STEP 4 - ASSEMBLE HEIGHT ADJ. STRAP
Place the spacer bushing (I) into the hole in the
height adjustment strap. Place the strap and bushing
between the hitch tubes, aligning them with the rear
hole. Fasten the hitch tubes together, with the strap
and bushing between them, using two hex bolts (A)
STEP 5 - MEASURE TRACTOR HITCH
Use the mark beside this paragraph to measure the
height of the tractor hitch. The mark is 10" from the
bottom of the page. If the tractor hitch is less than 10"
is 10" or more above the ground, go to
STEP 6a - ASSEMBLE HITCH BRACKETS
If the tractor hitch is less than 10" above the ground,
place the bent hitch bracket underneath the hitch
tubes and place the hitch bracket assembly on top of
the hitch tubes. Insert two hex bolts (B) through the
brackets, with the rear hex bolt between the cross
bolts in the hitch tubes. Secure the hex bolts (B) with
two nylock nuts (E). See fi gure 3.
Assemble the two spacers (J) onto the hitch pin and
secure the pin with the hairpin cotter (K). See fi gure 3.
HEX BOLT (A)
NYLOCK NUT (E)
SPACER
BUSHING (I)
HEIGHT
ADJUSTMENT
STRAP
NYLOCK NUTS (E)
HITCH BRACKET
ASSEMBLY
BENT HITCH
BRACKET
HEX BOLTS (B)
HAIRPIN COTTER (K)
SPACERS (J)
STEP 6b - ASSEMBLE HITCH BRACKETS
If the tractor hitch is 10" or more above the ground,
place the bent hitch bracket on top of the hitch tubes
and place the hitch bracket assembly underneath
the hitch tubes. Insert two hex bolts (B) through the
brackets, with the rear hex bolt between the cross
bolts in the hitch tubes. Secure the hex bolts (B) with
two nylock nuts (E). See fi gure 4.
Assemble the two spacers (J) onto the hitch pin and
secure the pin with the hairpin cotter (K). See fi gure 4.
NYLOCK NUTS (E)
BENT HITCH
BRACKET
HITCH BRACKET
ASSEMBLY
HEX BOLTS (B)
SPACERS (J)
HAIRPIN
COTTER (K)
HEX BOLT (C)
HITCH TUBE (L.H.)
PLASTIC TIE
NYLOCK NUT (E)
TUBE
MARKED
“77L”
HOUSING
MARKED “L”
STEP 2 - ASSEMBLE HITCH TUBES
The hitch tubes are stamped with a "77
" for the right tube. The sweeper
housing is marked with and "
" on the right side. See fi gure 1.
Hold the left hitch tube against the left side of the
" on the tube faces away from
the sweeper. Attach the hitch tube using two hex bolts
(C) and nylock nuts (E). Repeat for the right hitch tube,
" facing in toward the right side of the
STEP 3 - REMOVE PLASTIC TIE
Remove the plastic tie that fastens the height
adjustment tube to the front of the sweeper housing.
