WHEEL GEAR AND PAWL SERVICE
remove both wheels at the same
time to avoid mixing of parts. (The R.H. and L.H. ratchet
gears are not interchangeable.)
position of washers and snap rings during disassembly.
Remove one wheel from the sweeper.
Remove the retaining rings and washers which hold
the ratchet gear onto the brush shaft.
Remove the gear by sliding it off the brush shaft.
(Look for the drive pin, which may fall out of the brush
shaft when the ratchet gear is removed.) See fi gure
To reassemble, insert the drive pin through the hole
near the end of the brush shaft. Make sure the pin
slides back and forth easily in the shaft.
Lightly grease the shaft and fi ll the ratchet gear with
grease. Assemble the ratchet gear back onto the
Lightly grease the axle and the wheel's gear teeth
and then reassemble the wheel. The brushes should
during forward rotation of the wheel. If
the brushes are driven (rotated) by both forward and
reverse rotation of the wheel, the drive pin is jamming
in the ratchet gear. Disassemble to clean and lubricate
the drive pin and the ratchet gear.
Brush replacement should be done one brush
Remove the hopper bag from the sweeper.
Loosen the hex bolts and lock nuts on two single
brush retainers which clamp one brush to the double
which fasten the double brush retainers to the brush
Slide the brush out of the retainers, noting on which
side of the brush the bristles overlap. See fi gure 25.
Install new brush, making sure the bristles overlap on
the same side of the brush as before. See fi gure 25.
Wheels skid when sweeping.
1. Adjust height till brushes are 1/2" down
2. Stop sweeper. Remove obstruction.
3. Remove one wheel at a time to check for
obstruction or damage. Refer to Service
SERVICE AND ADJUSTMENTS
TROUBLESHOOTING
BRUSH ROTATION
BRUSH ROTATION
OVERLAP
BRISTLES
OVERLAP
BRISTLES
SINGLE
BRUSH
RETAINERS
DOUBLE BRUSH RETAINER
BRUSH
SHAFT
