12
Catalyst 6500 Series PFC3B and PFC3BXL Installation Note
78-16220-02
Applying the Label to the Supervisor Engine
Step 10 Depending on the software running on the switch, do one of the following steps to verify the installation:
• Cisco IOS software on the supervisor engine and the MSFC3
Verify that the switch is online. This indicates that the system acknowledges the new module and
has brought it online.
• Catalyst supervisor engine software on the supervisor engine and Cisco IOS software on the MSFC3
Enter the show module command to verify that the system acknowledges the new module and has
brought it online.
This example shows the output of the show module command:
Console> show module
Mod Slot Ports Module-Type Model Sub Status
--- ---- ----- ------------------------- ------------------- --- --------
1 1 48 10/100BaseTX Ethernet WS-X6248-RJ-45 no ok
5 5 2 1000BaseX Supervisor WS-SUP720-BASE yes ok
15 5 1 Multilayer Switch Feature WS-SUP720 no ok
...
Mod Sub-Type Sub-Model Sub-Serial Sub-Hw Sub-Sw
--- ----------------------- ------------------- ----------- ------ ------
5 L3 Switching Engine III WS-F6K-PFC3BXL SAD073702HH 0.250
Console>
If the installation is not successful, see the “Troubleshooting” section on page 13 for troubleshooting
information.
Applying the Label to the Supervisor Engine
The WS-F6K-PFC3B= and WS-F6K-PFC3BXL= kits include a packet of labels. Apply the “PFC3B” or
“PFC3BXL” label to the upper-left corner of the Supervisor Engine 720 front panel. (See Figure 7.)
Figure 7 Applying the Label
105886
Apply label here
