16
Connect to 100BASE-FX Ports
Follow these steps:
Install and Connect to GBIC Module Ports
Follow these steps:
For a list of supported modules, refer to the release notes on Cisco.com. For detailed instructions on
installing and removing modules, refer to the documentation that came with the GBIC module.
Step 1
Remove the dust plugs from the
100BASE-FX ports and the rubber
caps from the MT-RJ patch cable.
Store them for future use.
Step 2
Insert an appropriate cable into a 100BASE-FX port. Insert the other cable end into an SC
or ST port on the other device.
Step 1
Grasp the module on the sides, and
insert it into the switch slot until you
feel the connector snap into place.
Step 2
Insert an appropriate cable into the
module port. Insert the other cable end
into the other device.
M
O
D
E
SY
S
TEM
R
P
S
S TAT U
S
U
TIL
D
UP
LX
S
P
EE
D
1X
2X 3X
4X
5X
6X
7X
8X
100BASE-FX ports
GBIC module
12
11
2
3
4
5
6
7
8
9
10
GBIC module port
12
11
2
3
4
5
6
7
8
9
10
