Cisco Systems CATALYST 2950 Manual

A SERVICE OF

next previous

16

6 Connecting to DC Power

To connect the Catalyst 2950G-24-EI-DC or Catalyst 2950ST-24 LRE 997 switch to a DC-input power

source, follow the steps in this section.

Equipment That You Supply

You need to supply these tools and equipment:

• Ratcheting Phillips-head torque screwdriver

• Panduit crimping tool

• 6-gauge copper ground wire

• Four leads of 18-gauge copper wire

• Wire stripping tool

Ground the Switch

Follow these steps:

Step 1

Remove the ground lug and the two number-10-32 screws from the switch (on the rear panel

of the Catalyst 2950G-24-EI-DC switch and on the front panel of the Catalyst 2950ST-24

LRE 997 switch).

Step 2

If your 6-gauge ground wire is insulated,

strip it to 0.5 inch (12.7 mm).

0.5 inch (12.7 mm)