2-4
Cisco 4x InfiniBand Switch Module for IBM BladeCenter User Guide
78-17838-01
Chapter 2 Installing and Configuring the Server Switch
Configuring the Server Switch Module
Step 2 Set the on-board clock by entering the clock set command with the following variables:
• the time of day in hh:mm:ss format
• the day in dd format
• the month in mm format
• the year in yy format
The example that follows sets the date to 1:45 am on June 3rd, 2004:
Cisco BladeCenterH# clock set 01:45:00 03 06 04
To configure primary, secondary, and tertiary NTP servers to synchronize the Server Switch with the
network, follow these steps:
Step 1 Switch to Privileged Exec mode by entering the
enable
command.
Cisco BladeCenterH> enable
Cisco BladeCenterH#
Step 2 Switch to Global Configuration mode by entering the
configure terminal
command.
Cisco BladeCenterH# configure terminal
Cisco BladeCenterH(config)#
Step 3 Assign a primary NTP server by entering the
ntp
command with this information:
•
server-one
keyword
• IP address of the NTP server
Cisco BladeCenterH(config)# ntp server-one 10.2.0.13
Step 4 (Optional, Recommended) Assign a secondary NTP server by entering the
ntp
command with this
information:
•
server-two
keyword
• IP address of the NTP server
Cisco BladeCenterH(config)# ntp server-two 10.2.0.14
Step 5 (Optional, Recommended) Assign a tertiary NTP server by entering the
ntp
command with this
information:
•
server-three
keyword
• IP address of the NTP server
Cisco BladeCenterH(config)# ntp server-three 10.2.0.15
