12
Catalyst 6500 Series Switch and Cisco 7600 Series Router Wireless Services Module Installation and Verification Note
78-17121-04
Verifying the Installation
Figure 7 Ejector Lever Closure in a Vertical Slot Chassis
Verifying the Installation
Enter the show module command to verify that the system acknowledges the new module and has
brought it online.
This example shows the output of the show module command:
Router> show module 2
Mod Ports Card Type Model Serial No.
--- ----- -------------------------------------- ------------------ -----------
2 10 Wireless Services Module WS-SVC-WISM-1-K9 SAD092504JJ
Mod MAC addresses Hw Fw Sw Status
--- ---------------------------------- ----- ------------ ------------ -------
2 0001.0002.0003 to 0001.0002.0012 0.1 12.2(14r)S5 12.2 Ok
Mod Sub-Module Model Serial Hw Status
--- --------------------------- ------------------ ------------ ------- -------
2 Centralized Forwarding Card WS-F6700-CFC SAD092608SY 0.2 Ok
Mod Online Diag Status
--- -------------------
2 Pass
Router>
FAN
STATUS
SELECT
NEXT
24 PORT 100FX
WS-X6224
STATUS
ACTIVE
SUPERVISOR2
WS-X6K-SUP2-2GE
STATUS
SYSTEM
CONSOLE
PW
R MGMT
RESET
CONSOLE
CONSOLE
PORT
MODE
PCMCIA EJECT
PORT 1
PORT 2
Switch Load
100%
1%
SUPERVISOR2
WS-X6K-SUP2-2GE
STATUS
SYSTEM
CONSOLE
PWR MGMT
RESET
CONSOLE
CONSOLE
PORT
MODE
PCMCIA
EJECT
PORT 1
PORT 2
Switch Load
100%
1%
63587
All ejector levers flush
with module faceplate
