Cisco Systems 1200 Manual

next previous

WLANE-C Installation

 Installation of the WLANE-C

Step 1: Unpack the box, check for all components.

Step 2: Make sure the Enclosure is on a level surface. Extend

T-bars and adjust them to 3/4" from the bottom of the T. See

figure 1. If the Enclosure is not at proper height, adjustments

can be made by loosening and moving the T bars to the

appropriate height.

Level Surface

3/4"

T Bars

CeilingTile

Figure 2

21"

Step 3: Remove one 2x2 or 2x4 ceiling tile from your ceiling

grid.

Step 4: Make a 6" x 8" cut in the center of the selected tile. See

figure 2.

Figure 1

 Installation of the WLANE-C

Step 5: Place enclosure through the hole and make sure the T-

bars are resting on the Ts. See figure 3.

T Bars

CeilingTile

Figure 3

T Braces

21"

Step 6: The Enclosure should be about 1/4" below the tile. See

figure 4.

CeilingTile

Figure 4

1/4"