73
2
Perform the procedure under “To switch the Data Projector connection profile”
(page 66) to switch the Data Projector connection profile to “Manual Connection
3”.
z This will cause the “Standing by for connection...” screen to appear in the projection
area. Confirm that the screen shows “Manual Connection 3” for the connection profile.
3
On the computer that has the YW-2 wireless adapter connected, double-click the
icon to display the Wireless Connection window.
z This step is not necessary if the Wireless Connection window is already displayed.
4
On the Wireless Connection window, select “Switch Connection Profile” on the
“Connection” menu.
z This will display a dialog box for switching the connection profile.
5
Click the [New] button.
z This will display a dialog box for configuring a new manual connection profile.
6
On the dialog box for configuring the manual connection setup, configure the
settings so they are the same as those that you configured for Manual
Connection 3 in step 1 of this procedure.
z For the IP address, use any address that is different from the Data Projector’s address
(192.168.10.1). For example, you could use 192.168.10.2.
z For details about each of the settings on the dialog box, see “Manual Connection Setting
Reference” (
page 77).
