A SERVICE OF

logo

Open as PDF
next previous
1-20 BE-1204B-BC • BE-1206B-BC
Chapter 1 Preparations of operation
4-4 Attachment of Embroidery Hoop and Frame
!
!!
! Tubular square hoop
W1243Q
1. Loosen the thumb bolt M6 [1] to draw it to the center.
2. Align the positioning hole on the tubular round arm frame [4] with the positioning pin [3] (S58665)
on the X-feed sash [5] (S58650), and fit the tubular round arm fixing nut [2] on the back side of the
thumb bolt M6 [1] into the hole on the X-feed sash.
3. While keeping the nut in the hole, slide the thumb bolt M6 toward the edge and tighten it firmly at
the outermost point.
[1]
[2]
[4]
[3]
[5]