1 YEAR LIMITED WARRANTY
For a period of 1 year from date of purchase, Atd Tools Inc. will repair or replace, at its option, without charge, any
of its products which fails due to a defect in material or workmanship, or which fails to conform to any implied
warranty not excluded hereby.
Performance of any obligation under this warranty may be obtained by returning the warranted product, freight
prepaid, to Atd Tools Inc. Warranty Service Department, 114 I-70 Trade Center Drive, St. Peters, MO 63376.
Except where such limitations and exclusions are specifically prohibited by applicable law. (1) the CONSUMER'S
SOLE AND EXCLUSIVE REMEDY SHALL BE THE REPAIR OR REPLACEMENT OF DEFECTIVE PRODUCTS
AS DESCRIBED ABOVE, and (2) Atd Tools Inc. SHALL NOT BE LIABLE FOR ANY CONSEQUENTIAL OR
INCIDENTAL DAMAGE OR LOSS WHATSOEVER, and (3) THE DURATION OF ANY AND ALL EXPRESSED AND
IMPLIED WARRANTIES, INCLUDING WITHOUT LIMITATION, ANY WARRANTIES OF MERCHANTABILITY AND
FITNESS FOR A PARTICULAR PURPOSE, IS LIMITED TO A PERIOD OF 1 YEAR FROM DATE OF PURCHASE.
Some states do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply
to you. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above
limitation or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have
other rights which vary from state to state.
REPLACEMENT PARTS
When ordering replacement parts, please refer to the model number / serial number found on the product, then give
the part number and description.
Available Parts: (See Page 4) Not all components of the lift are replacement items, but are illustrated as a
convenient reference of location and position in the assembly sequence. Call or write for current pricing: Atd Tools
Inc. 114 I-70 Trade Center Drive, St. Peters, MO 73376
Tel. (636)272-9050 Fax (636)272-9044
Possible Causes
Corrective Action
Hydraulic unit will not lift load
Hydraulic unit bleeds off after lift
Will not lift to full extension
Release valve not tightly closed
Overload condition
Fluid level low
Fluid level low
Air trapped in system
Release valve not tightly closed
Overload condition
Hydraulic unit malfunction
Ensure release valve tightly closed
Remedy overload condition
Ensure release valve tightly closed
Remedy overload condition
Contact Atd Tools Tech. Service
Ensure proper fluid level
Ensure proper fluid level
With ram fully retracted, remove oil filler
plug to let pressurized air escape, reinstall
oil filler plug
Poor lift performance
Lift will not lower after unloading
Reservoir overfilled
Linkages binding
Drain fluid to proper level
Clean and lubricate moving parts
TROUBLESHOOTING
Symptom
5
