5. Ensure tha he replacement ery is oriented with the ve on the right side and the on the le side,
just as the old
ery came out.
6. Connec
he red #4 jumper cable and red recharging wire to the
ve (+) terminal (also marked with red),
then connec
he black #4 jumper cable and recharging wire to the nega
(-) terminal. Double check all
conne
and ghten.
7. Taking care no
o damage the circuit board, slide the new
ery in
8. Replace the ery compartment cover and secure in place with the Phillips head screws.
SPECIFICATIONS
ITEM # ... . ... …......... . ..... . ... .ATD-5922
VOLTAGE ... . . .... . . . . . . . . .... . ... .12V DC
BOOST POWER .... . ... . . . ..... . ... .700 CRANKING AMPS
PEAK AMPS… …...…….. . . .. . . . . . . . . . ….1700 AMPS
BATTERY TYPE . . . . . . . . . . . . . . . . . . . . ..SEALED, LEAD- ACID, RECHARGEABLE, MAINTENANCE-FREE, 12V DC, 22-AMP-HOURS
BOOSTER CABLES . . . ... . . . . .... . . . …43”, #
4 GAUGE 100% COPPER CABLES WITH 500 AMP "ALLIGATOR" CLAMPS
DIMENSIONS ….... . . . . . . . . . . . . . . .. . 11.8” x 10.6” x 3.5” (30 x 27 x 9 CM)
