ATD Tools ATD-5200 Manual

next previous

WARNING:Alwaysuseairhoseandcouplingswithaminimumworkingpressureratingofatleast

1‐1/2timesthemaximumworkingpressureratingofthetool.

WARNING:Donotdepressthetooltrigger/leverwhenconnectingtheairsupplyhose.

WARNING:Donotlock,tape,wire,orotherwisedisablethe“ON/OFF”valveinthe“ON”position.

Thetriggermustalwaysbefreetoreturntothe“OFF”positionwhenreleased.

WARNING:Whenthetoolisnotinuse,shutofftheairsupplyandpressthetrigger/levertodrain

theairsupplyline.Ifthetoolisnottobeusedforaperiodoftime,firstlubricate,disconnectfromtheair

supplyandstoreinacleananddrylocationat

averageroomtemperature.

NOTE:TypicalAirSupplyInstallation



Alwaysuseclean,dryair.Dust,corrosivefumesand/orwaterintheairlinewillcausedamagetothetool.

Draintheairtankdaily.Cleantheairinletfilterscreenonatleastaweeklyschedule.Therecommended

hookupprocedurecanbeviewedintheabovefigure.

ATD‐5200SpecificWarnings:

INSPECTION:

Checkforwornparts,airleaks,anddamaged,looseormissingpartsbeforeoperating.Checktank

operationbyconnectingairtoairnipple andclosingballvalve.Verifythatthereissufficientair

flowcomingfromnozzle/hoseassembly.Anannualtank/componentinspectionisrecommended.

WARNING:

Failuretoheedthefollowingmayresultinpersonalinjuryand/orpropertydamage.

NEVERleaveunitunattendedwhenopera tingorevacuating.

NEVERusenearopenflameorheatsource.

ALWAYSraisedrainbowlandclosemainvalvebeforeemptying.

ALWAYSdisconnectairsupplyafteremptying.

NEVERuseunitforhandlinghighly

volatilefuelsandfluids.

USEONLYthenozzleassemblyprovided.

DO NOT tamperwith orremove thepop‐offvalveand preset,nonadjustableregulator as they

havebeeninstalledforprotection.