Before You Start – Assembly and Installation
Mounting the Grinder to the Workbench
Before attempting to use this grinder, it must be properly mounted to a workbench or grinding stand (ATD-10557).
CAUTION! Bench grinders vibrate. Grinder movement during high-speed rotation may cause
injury or damage to the workpiece or operator. Mount the grinder securely to a sturdy workbench
or grinding stand.
1. Position the gri
nder on the workbench.
2. Mark the workbench through the two mounting holes located in the grinder base.
3. Drill holes in the workbench at the marks.
4. Using two long bolts, washers, lock-washers and nuts, as shown (not supplied), secure the
grinder to the workbench.
Hex nut
Flat washer
Eye Shield Installation
Eye shields must be installed before operating the bench grinder.
1. Mount the left and right shield rods to the inside of the wheel guards using hex bolts.
2. Once shield rods are firmly in place, slide the shield bracket onto the shield rod.
3. Tighten the carriage bolt, leaving it loose enough to allow the safety shield to be raised and
lowered easily
