2
2
1
1
9
TEST INSTALLED FITTING
With HANDLES (1) in OFF position, turn on WATER
SUPPLIES (2) and check all connections for leaks.
Remove AERATOR (3).
Operate both HANDLES (1) to flush water lines thoroughly.
Replace AERATOR (3).
5
2
3
4
3
CHECK DRAIN CONNECTIONS
Operate POP-UP KNOB (4) and fill lavatory with water.
Check that DRAIN STOPPER (5) makes a good seal
and retains water in SINK. If DRAIN STOPPER (5)
does not seal properly, please refer to Troubleshooting
section in these instructions.
Release POP-UP KNOB (5) down and check all drain
connections and "P" trap for leaks. Tighten
if necessary.
11
“P” TRAP
WASTE
OUTLET
4
AERATOR (6) may accumulate dirt causing distorted and reduced
water flow. Remove AERATOR (6) and rinse clean.
To change direction of handle rotation, proceed as follows:
10
SERVICE
1
6
If spout drips, operate handles several times from OFF to ON
position. Do not force - handles turn only 90˚.
4
Turn VALVE in OFF position.
Loosen HANDLE SCREW (2), and pull HANDLE (1) off ADAPTOR (3).
Turn VALVE to OFF position.
To change direction of handle
rotation, proceed as follows:
Pull ADAPTOR (3) off VALVE STEM (5) and turn 90˚ in a way that flat
in ADAPTOR (3) catches a different flat in on VALVE STEM (5).
If spout drips, operate HANDLES (1) several times from OFF to ON
position. Do not force-handles turn only 90˚.
Reinstall ADAPTER SCREW (3), HANDLE (1) and HANDLE SCREW (2).
Remove ADAPTOR SCREW (4).
5
FLAT
90˚
M968806 REV 1.3
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A
CLOTH WITH A COARSE SURFACE.
CARE INSTRUCTIONS:
