TROUBLE SHOOTING GUIDE
Electronic Range Control - (ERC) (Models w/One Piece Control)
TO AVOID THE RISK OF ELECTRIC SHOCK, PERSONAL INJURY OR DEATH DISCONNECT POWER
BEFORE SERVICING, UNLESS TESTING REQUIRES IT.
RC231002 Rev. 3 54
PROBLEMS POSSIBLE CAUSE CORRECTION
A. Display flashes the
Time-of-Day
1. Power failure. 1. This is a normal condition w
Press the "CLOCK" button
B. No Display - E.R.C.
totally inoperative
1.
2.
No power to range.
No voltage to relay/power
supply circuit board.
1.
2.
Check house fuse or circuit
wall outlet or junction box.
Check for 120 VAC at circuit
If no voltage is indicated, ch
indicated, replace E.R.C.
C. No Display - Range still
operates in bake, broil,
clean functions.
1. Defective E.R.C. 1. Replace E.R.C.
D. Dim Display - Range
may or may not operate
1.
2.
3.
Low supply voltage to
range.
Low volatge to E.R.C.
Defective E.R.C.
1. Check input voltage at wall
should be 108 - 132 VAC). I
VAC, contact power compa
voltage checks good, proce
Check for 108 - 132 VAC to
E2.
If voltage is low, check wirin
terminals E1 and E2.
If Steps 1 and 2 check goo
E. Display operates
normally. Bake or broil
relays do not operate.
1. Open bake/broil relay coil. 1. If Bake/On or Broil/On appe
VAC from terminals E2 to E
terminals E2 to E6 and E7 f
E4/E6 then resolve loss of p
E7 or E5 replace E.R.C.
