20
Client Mode
Client Mode Settings
Alias Name
Display the name of this device.
Band
You can choose one mode of the following you need.
~ 2.4GHz (B): 802.11b supported rate only.
~ 2.4GHz (G): 802.11g supported rate only.
~ 2.4GHz (B+G): 802.11b supported rate and 802.11g supported
rate. The default is 2.4GHz (B+G) mode.
SSID
The SSID differentiates one WLAN from another; therefore, all
access points and all devices attempting to connect to a specific
WLAN must use the same SSID. It is case-sensitive and must not
exceed 32 characters. A device will not be permitted to join the
BSS unless it can provide the unique SSID. A SSID is also
referred to as a network name because essentially it is a name that
identifies a wireless network.
Security
Click Setup button to enter the Wireless Security Setup page.
Authentication: Select an Authentication from the pull-down list
including Open system or Shared Key, Open System, Shared
Key, WPA-PSK and WPA2-PSK.
Encryption: Select either None or WEP.
Apply Changes: Press to save the new settings on the screen.
Reset: Press to discard the data you have entered since last time
you press Apply Changes.
